Show pagesource Old revisions Backlinks LCD-projector Read the instructions carefully before use. Abuse may lead to bulb damage. Pay special attention to cooling time and minimum time in use. Power cable is stored in a locked cabinet. Inputs: VGA HDMI S-Video Coaxial YPbPr Quick Guide to the Projector: Hook up the power cable. Turn on the switch on the back of the projector for standby. During standby, the projector can be turned on with the button on the bottom of the projector or the remote. Please note that heating up takes up to a minute! Do NOT switch off or unplug the projector while heating up! This may DAMAGE the bulb! Minimum time of use each time is 10 minutes. You can select the input with the remote. VGA is labeled “Computer”. After use, set the projector back to standby by tapping the power button twice. Bulb turns off and the device starts cooling. While cooling, a red light will blink on the bottom. This may take few minutes. Do NOT unplug the device while cooling. Red light will stop blinking (stays on) when the cooling is done. Now you can switch the standby off. Return the power cable neatly to the AV-cabinet.